Summary: <br> Historically, AP-on-a-Stick (APoS) surveys were the only way to find out where to place the access points. We didn’t have any of the fancy software we have today to predict how the Wi-Fi signal will behave in our space. However, we still perform APoS today. In this episode, we will explain why we still use them and how they can be beneficial to us Wi-Fi Engineers.<br> <br> <br> <br> <br> <br> <br> <br> APoS utilizes an AP that will be deployed on-site. The AP would be installed on a “stick” and is used to measure how the Wi-Fi signal behaves in the space that is being surveyed. The advantages are it takes into consideration the behavior of an RF wave and the attenuation, reflection, diffraction, scattering, etc. The disadvantage is it takes time and materials to achieve.<br> <br> <br> <br> Historically, that was the way we used to define where to place the APs. We would start in a corner of a building and place the first AP, measure the signal to define the edge of the Wi-Fi cell and go on to the next measurement until you covered the whole site and defined the different AP locations.<br> <br> <br> <br> The introduction of tools allowed us to model and predict how the Wi-Fi signal will propagate in a given space. This allows us to plan and perform our Wi-Fi design “on paper” so to speak. In order for this type of predictive design to be accurate, we still need to understand the physical environment. However, we can predict the signal prediction in the software and save some time.<br> <br> <br> <br> Why do we still use APoS then? In some environment and cases, the predictive design will not be accurate enough for us to be confident in the design. In these cases, we now use the APoS to validate some of the AP locations defined during the predictive design phase. How much validation do we need to do? It depends
